HP 3000 99x Family Installation Manual page 55

d. If the System Exerciser (SX) is available, run it to further verify system operation.
14.Install additional peripherals.
a. Unpack peripherals.
b. Power down the system.
c. Install additional peripherals in the A1884A/A1897A expansion cabinets; see
99x/T-Class Systems Expansion Cabinet Installation Guide (PN A1809-90006).
d. Connect bus converter (BC) cards in the PMB card cage to HP-PB I/O card cages in
the expansion cabinets.
e. Make MUX connections and install MDPs (T-Class only).
f. Make DTC connections to the console/LAN card.
g. Connect other peripherals to HP-PB I/O cards.
15.Reboot and reconfigure.
a. Reboot the operating system (OS).
b. 99x: If the hardware configuration (I/O cards, peripherals, etc.) does not match the
MPE/iX configuration, modify the MPE/iX configuration. See the listing of default
configuration groups in Appendix A (MPE/iX Configuration and SYSGEN) in this
manual. If necessary, use SYSGEN to modify the configuration group.
c. Configure the network.
d. Configure the OS for the PowerTrust UPS if one is included with the system.
e. Configure Access Port (AP) for a remote console.
16.Test powerfail recovery (990/992/890 without UPSs) and Transfer of Control
(TOC).
17.(Recommended.) Run diagnostics: Run MEMTEST at the PDC interface, then run
EDPROC and EDBC at the ISL prompt. On 997/T600 Systems, use ODE (Off-line
Diagnostic Environment) to run UDIAG, JAVADIAG, and KEYDIAG.
Chapter 3
Installation
Summary
3-7