HP 3000 99x Family Installation Manual page 121

For predictive support to function correctly, the AP should be set to
NOTE
single mode. In single mode, the port is a normal session port.
9. To change parameters, enter Y in response to the prompt. The system displays a change
menu:
Enter your changes. (CR) retains the current value.
Current mode: Multiple
Select the new setting (S=single, M=multiple): S
Current Password:
New password (1 to 24 displayable characters or space if
no password is to be required): new password
Current Password fault limit: 03
New number of password faults (Range: 099 or space, space or 0 will
permit unlimited password faults.): 03
New remote console access configuration:
Remote CS:
Mode:
Password:
Password Faults:
Remote console is now enabled.
CM>
10.If you choose to disable remote console access, enter DR.
CM> DR
11.Enter CO to return the console to console mode.
Chapter 3
(current password)
Enabled
Multiple
(new password)
03
Installation
Rebooting and Reconfiguring
3-73