Replacing The Pci Card Cage; Figure 2-36 Removing The Pci Card Cage Cover - HP 9000 rp3440 Installation Manual

Installing and Configuring
Removing and Replacing the PCI Card Cage
Step 4. Grasp the PCI card cage cover and slide it away from the bulkhead end of the cage, then lift the
cover off (Figure 2-36).

Figure 2-36 Removing the PCI Card Cage Cover

Step 5. Unscrew the bulkhead screw that holds the accessory card holder (if installed) in place.
Step 6. The PCI slots are now accessible for installation of additional cards.

Replacing the PCI Card Cage

To replace the PCI card cage, perform the following steps:
Step 1. Hold the PCI card cage cover in mounting position and slide it toward the bulkhead end of the cage.
Step 2. Hold the PCI card cage above the chassis mounting position, such that the bulkhead end of the cage
is toward the rear of the server. (Figure 2-35.)
Step 3. Hold the PCI card cage release lever in the raised position and lower the card cage into the server
chassis.
Step 4. Press the PCI card cage release lever into the lowered position to lock the card cage into the server
chassis.
54
Chapter 2