Table of Contents
Advertisement
Shutting Down
Using the suspend or hibernation function
It is necessary to set the suspend or hibernation function using the Panasonic Power
Management Setting.
1
Click [Start] - [Settings] - [Control Panel]
2
Double-click [Panasonic Power Management]
3
Click [Operation Setting], then set [Suspend] or [Hiber-
nation] for [Power Switch]
4
Click [OK]
Power Switch
N O T E
If the internal speaker is off by pressing
not be heard.
You can also run [Power Management] from the Setup Utility (
C A U T I O N
Save all data before powering off your computer.
If the power switch is held for more than four seconds at the ON position,
the "beep" sound will come out again and the power will go OFF without
activation of the suspend or hibernation function. Do not slide the power
switch and hold it for more than four seconds.
When restarting from or shutting down to the suspend or hibernation mode,
do not touch the trackball (or move the mouse (serial or PS/2 type) if one is
connected). There are cases where these devices will fail to operate; you
will have to restart your computer using the keyboard (
Do not use the suspend or hibernation function during the following peri-
ods (you may corrupt your data or file):
• While the FDD, HDD or CD-ROM is being used.
• While playing/recording audio files.
• While communications software is being used.
• While PC Cards (a SCSI card or ATA card etc.) are being used.
Do not touch the power switch
while your computer is entering
the suspend or hibernation mode.
At the "beep" sound, release your finger.
Fn
Suspend Mode
Hibernation Mode
+
, the "beep" sound will
F8
page 76).
page 18"NOTE").
o r
1 9
Advertisement
Table of Contents
