Table of Contents
Advertisement
Reinstallation Procedure
If the hard disk partitions have been changed since the computer was purchased
To leave the current partition settings
Proceed to Procedure 1 on next page.
To restore the partition settings to factory default
(1) Insert the FIRSTAID FD, which you made earlier, into the floppy disk drive.
Then turn the computer on.
(2) Select [2. Return hard disk partitions and hibernation data area to factory de-
fault.]
(3) In response to the confirmation message, press
(4) When the message [Hibernation data area created.] is displayed, confirm that
the FIRSTAID FD is in the floppy disk drive then press any key.
The computer will reboot. Then continue with step
page.
To change the partition settings
(1) Insert the FIRSTAID FD, which you made earlier, into the floppy disk drive.
Then turn the computer on.
(2) Use the FDISK command to delete all partitions.
(3) Use the HBUTIL command to create the hibernation data area (
(4) Use the FDISK command to create MS-DOS partitions.
(5) Press
+
+
Alt
Ctrl
(6) Format each of the MS-DOS partitions.
Next, proceed to Procedure
C A U T I O N
Make sure to reinstall the Windows 95 operating system on the C: drive.
to reboot the computer.
Del
on next page.
2
.
Y
of Procedure
on next
2.
1
page 71).
5 9
Advertisement
Table of Contents
