Shutting Down; Standby/Hibernation Function - Panasonic CF-73 Series Reference Manual

Dealing with Problems (Advanced)
Setup Utility
[Advanced] and [Boot] menu can not
be registered
Some items in [Security] menu can not
be registered
F9 does not work

Shutting Down

Windows cannot be shut down or
restarted

Standby/Hibernation Function

Unable to enter standby or hibernation
mode
Unable to automatically enter standby
or hibernation mode
The computer does not resume
Restart the Setup Utility with the Supervisor Password.
Restart the Setup Utility with the Supervisor Password.
Restart the Setup Utility with the Supervisor Password.
If a USB device is connected, try removing it.
It may take one or two minutes to shut down.
If a USB device is connected to the computer (note: only for some USB
devices), remove the USB device temporarily. If the problem persists, restart
the computer.
It may take one or two minutes to enter the standby or hibernation mode.
The computer may not enter standby mode properly and seems to be frozen in
the case that the computer is communicating via the modem. If this happens,
press the power switch for four seconds or more to forcibly turn your computer
off.
If there is a disc in the CD/DVD drive that has been formatted using B's CLiP,
the computer will not enter standby or hibernation mode. Remove the disc.
If a peripheral is connected to the computer, disconnect the device.
If there is a disc in the CD/DVD drive that has been formatted using B's CLiP,
the computer will not enter standby or hibernation mode. Remove the disc.
Did you press the power switch and hold it for four seconds or more? If you
press the power switch and hold it for four seconds or more, the power will be
turned off forcibly. In this case, all unsaved data will be lost.
Did you disconnect the AC adaptor or the battery pack while the computer was
in standby mode?
• If the computer's power supply is disconnected while the computer is in
standby mode, the unsaved data will be lost.
• Power is also consumed when the computer is in hibernation mode. Connect
the AC adaptor.
138