Shutting Down; Standby/Hibernation Function; Battery Indicator - Panasonic CF-73 Series Reference Manual

Dealing with Problems (Advanced)
Setup Utility
Some items in [Security] menu can not
be registered
F9 does not work

Shutting Down

Windows cannot be shut down or
restarted

Standby/Hibernation Function

Unable to enter standby or hibernation
mode
Unable to automatically enter standby
or hibernation mode
The computer does not resume

Battery Indicator

The red indicator lights.
The red indicator blinks
The orange indicator blinks
Restart the Setup Utility with the Supervisor Password.
Restart the Setup Utility with the Supervisor Password.
If a USB device is connected, try removing it.
If a USB device is connected to the computer (note: only for some USB
devices), remove the USB device temporarily. If the problem persists, restart
the computer.
If a peripheral is connected to the computer, disconnect the device.
Did you press the power switch and hold it for four seconds or more? If you
press the power switch and hold it for four seconds or more, the power will be
turned off forcibly. In this case, all unsaved data will be lost.
The battery level is very low (the charge is less than approx. 9% capacity).
Connect the AC adaptor. You can use the computer when the battery indicator
light is orange. If you do not have an AC adaptor, save your data and power off
your computer. After replacing the battery pack with a fully charged one, turn
your computer on.
Quickly save your data and power off your computer. Remove the battery pack
and disconnect the AC adaptor, then connect them again. If the problem
persists, contact Panasonic Technical Support. Possible failure in the battery
pack or charging circuit.
Battery cannot be recharged temporarily because the internal temperature of
the battery pack is outside of the acceptable temperature range for recharging.
Once the allowable range requirement is satisfied, charging begins
automatically. Your computer can be used normally in this state.
94