Table of Contents
Advertisement
9
Setting USB function
Set Windows 95 CD-ROM in the CD-ROM drive.
1 .
Click [Start], then click [Run]. Type "L:\other\updates\usb\usbsupp.exe", then
2 .
click [OK].
At the confirmation message, click [Yes].
Read the [END-USER LICENSE AGREEMENT] and click [Yes].
3 .
Installation will be aborted if [NO] is pressed.
€
After Microsoft ScanDisk completes, installation will start. At the confirma-
4 .
tion message, click [OK].
The computer will reboot.
Click [Start], then click [Run]. Type "L:\other\updates\usb\usbupd2.exe", then
5 .
click [OK].
Click [Start], then click [Run]. Type "c:\util\usb\usbcopy.bat", then click [OK].
6 .
When [Finished-usbcopy] is displayed in the title bar of the DOS window,
7 .
click the [
]-mark in the upper right corner of the DOS window to close it.
X
Double-click [System] in [Control Panel].
8 .
Click [Device Manager], then select [PCI Universal Serial Bus] for [Other
9 .
device]. Click [Remove] and [OK].
Click [Close] in [System Properties].
1 0 .
Click [Start], then click [Shut Down]. Select [Restart the computer?], then
1 1 .
click [Yes].
C A U T I O N
When using a USB device, set [Enabled] for [USB Port] in [Supervisor Setup].
[Disabled] is the default setting. (
page 78, 79)
6 7
Advertisement
Table of Contents
