Table of Contents
Advertisement
Dealing With Problems
Setup Utility
is displayed
[Supervisor Setup]
is not displayed in
the menu
[User Password]
cannot be selected
Connecting Peripherals
Your peripheral
does not work
(An error occurs
while installing
the driver)
Unable to print
The cursor does
not move from
mouse operations
5 6
Enter the User Password. If you have forgotten it, contact
Panasonic Technical Support.
At the start of the computer when
enter the Supervisor Password. When both the User Password
and Supervisor Password have been set, if you enter the User
Password, [Supervisor Setup] will not be displayed.
If [Supervisor Setup] is not displayed even after entering the
Supervisor Password, you have to delete the User Password.
Run the Setup Utility again, and input the Supervisor Password.
[User Password protection by user] in [Supervisor Setup] may
be enabled.
You need to use drivers conforming to OS*. Some earlier driv-
ers will no longer work.
For more information, please ask the manufacturer of the driver
in question.
®
* Windows
95 Version 4.00.950C (OSR-2.5)
Check the computer-printer connection.
Make sure the printer is on.
Make sure the printer is in the on-line state.
Make sure paper is in the printer tray and there is no paper
jam.
Has the Setup Utility been used to set [Parallel Port] to [378],
[278] or [3BC]?
Check the connection.
Confirm that the device driver for the mouse works.
Please refer to the reference manual of the device.
Try setting the [Track Ball] to disable in the Setup Utility.
Has the Setup Utility been used to set [Serial Port] to [2F8]
or [3F8]?
Check your mouse connection, then reboot the computer from
the keyboard.
From the keyboard, you may choose to press down on
then select [Shut Down].
is displayed, you have to
Advertisement
Table of Contents
