Table of Contents
Advertisement
Setup Utility
Supervisor Setup
If a supervisor password has been set, the password input screen will appear. Input the
supervisor password.
Parallel Port
M o d e
D M A
Infrared Port
ASK Mode
D M A
Serial Port
Sound Port
Sound Blaster compatible I/O
WSS CODEC I/O
I R Q
D M A - A
DMA-B (Sound Blaster)
USB Port
Boot up Drive
• Supervisor Password
User Password protection by user
PCI clock control*
(To display the items marked with an asterisk (*), move the cursor to the
bottom of the screen to cause it to scroll down.)
[Sound Port]
Select the sound chip operation setting. If [Disabled] is selected, all sound related
settings are disabled.
[Sound Port: Sound Blaster compatible I/O]
Set the I/O address for the Sound Blaster compatibility mode.
[Sound Port: WSS CODEC I/O]
Set the I/O address for WSS CODEC.
[Sound Port: IRQ]
Set the IRQ for the sound chip.
It is not possible to select the same IRQ as that selected for the parallel port.
[Sound Port: DMA-A] [Sound Port: DMA-B]
Set the DMA for the sound chip. Make sure that the settings for DMA-A and DMA-
B do not overlap, and that neither of them overlaps with the DMA setting for the
parallel port or the infrared port.
7 8
Supervisor Setup
[ Port 378, IRQ 7 ]
[ Bidirectional ]
N o n e
[ Port 2F8, IRQ 3 ]
[ Disabled ]
[ DMA 0
[ Port 3F8, IRQ 4 ]
[ Enabled
[ 220h
[ 530h
[ IRQ 5
[ DMA 7
[ DMA 1
[ Disabled
[ FDD -> HDD
[ Disable ]
[ Enable
]
]
]
]
]
]
]
]
]
page 38
]
Advertisement
Table of Contents
