Starting Up/Shutting Down - Panasonic CF-M34 Operating Instructions Manual

Starting Up/Shutting Down

Starting Up
Latch
2
1
Power
Indicator
Power Switch
14
1
Open the display
1 Lift up the latch.
Lift open the display.
2
2
Turn your computer on
Slide the power switch and hold it for approximately one second until the power
indicator turns on before releasing it.
CAUTION
After confirming that the power indicator has turned on, avoid the following
until Windows has completed loading.
• Connecting or disconnecting the AC adaptor.
• Touching the power switch.
• Performing any keyboard, touch pad, touchscreen (or external mouse) op-
erations.
• Closing the display.
Once the computer is powered off, you must wait at least ten seconds before
powering it on again.
When the CPU temperature rises, the computer may not power on to prevent
the CPU from overheating. Should this happen, allow the computer to cool
down then switch the power on again.
If the computer still does not power on, contact Panasonic Technical Support.
NOTE
When the power is turned on, sometimes the message "Warming up the system" is
displayed or the battery indicator alternately blinks green and orange, and start-up
takes longer than usual (a few minutes or more). This function is designed to prevent
hard disk drive malfunctions that may occur at low temperatures. Please wait for the
computer to start up.
If [Enter Password] is displayed,
Enter your password* and press Enter .(
Enter Password [
*
Supervisor Password or User Password set in the Setup Utility (not
the Windows password).
When an application or file that was previously displayed
appears on your screen,
the standby or hibernation function (
been set.
The correct password
]
Three incorrect attempts
or
No password for about a minute
"Standby/Hibernation Functions") has
"Security Measures")
Will Start
Will Not Start
(Power off)