Table of Contents
Advertisement
Infrared Data Communications
Your computer is equipped with an infrared communication port enabling you to transfer
data without a cable.
1
Set the address of your infrared communications port to
e n a b l e
Run the Setup Utility, then set infrared address for [Infrared Port] and set [Dis-
abled] for [ASK Mode] in [Supervisor Setup]. (
2
Install the Windows 95 infrared communication driver
C A U T I O N
To install the infrared communication driver after reinstallation;
You must insert the Windows 95 CD-ROM (included) after Step
Therefore a PC Card-compatible CD-ROM drive should be connected. (See the
manual included with your CD-ROM drive for details on how to connect it.)
Click [Start], then [Settings], then [Control Panel]. Double-click the [Add New
1 .
Hardware].
When the [Add New Hardware Wizard] opens, click [Next].
2 .
The following message will be displayed: "Do you want Windows to search for
3 .
your new hardware?". Select [No], then click [Next].
Under [Hardware types], select [Infrared], then click [Next].
4 .
When the [Add Infrared Device Wizard] opens, click [Next].
5 .
Under [Manufacturers], select [Standard infrared devices], then click [Next].
6 .
In the port selection window, select [Generic Ir Serial Port (COM2)], then click
7 .
[Next].
Select [Use default ports], then click [Next].
8 .
The infrared communication driver will be set up.
Click [Finish].
9 .
4 0
page78)
below.
8.
Advertisement
Table of Contents
