Table of Contents
Advertisement
The cursor does
not move from
trackball opera-
tions
The device con-
nected to the se-
rial port does not
work
A PC Card does
not work
You do not know
the available
RAM module
The RAM module
Make sure the RAM module has been properly inserted.
has not been rec-
ognized
The address map
Click [Start] - [Settings] - [Control Panel]. Double-click [Sys-
for IRQ, I/O
tem]. Check the address map by going to [View Resources] in
port address, etc.
[Device Manager] - [Computer] - [Properties].
is unclear
A USB device
does not work
Confirm that the device driver for the mouse works.
Please refer to the reference manual of the device.
Try setting the [Track Ball] to enable in the Setup Utility.
Has the Setup Utility been used to set [Serial Port] to [2F8]
or [3F8]?
Check the connection.
Confirm that the device driver for the serial port works. Please
refer to the reference manual for the device.
Confirm that two mouse devices are not connected, one
through the ext. keyboard/mouse port and the other through
the serial port.
Try setting the [Track Ball] to disable in the Setup Utility.
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
A driver for Windows 95 may need to be installed.
Note that after a driver is installed, the computer must be
rebooted.
Check that the proper port settings have been made.
Read the PC Card's manual. Or, you may need to call the
source of the PC Card.
When using a CardBus type card, no other types of cards can
be used.
Some ZV Cards may not work if installed in slot 2.
page 46
Has the Setup Utility been used to set [USB Port] to [En-
abled]?
Make sure a driver is installed.
Contact the manufacturer of the product.
5 7
Advertisement
Table of Contents
