1-9. Contents of the EEPROM and FRAM Data
The data that is stored in the EEPROM and FRAM on the respective boards, is shown below.
n
Part numbers of the following ICs are shown in Vol. 2 Section "1. Spare Parts" of the separate Mainte-
nance Manual are the ICs before saving the data contents.
Board
Ref. No.
(address)
AT-148
IC220
(A-2/A side)
IC221
(A-3/A side)
DPR-261
IC507
(F-10/A side)
PA-272
IC8
(B-1/B side)
VA-226
IC701
(D-12/A side)
*1: IC8 on the PA-272 board cannot be replaced because the data cannot be re-set.
When IC needs to be replaced due to defective IC, contact your local Sony Sales Office/Service Center.
BVP-E30/E30P M-V1
EEPROM/
Contents of the saved data
FRAM
FRAM
Reference file setting data
Scene file setting data
Lens file setting data
Operator file setting data
VF menu setting data
EEPROM
Factory adjustment data of
DPR-261 board
(except SC Frequency data)
EEPROM
Factory adjustment data of
CCD block
SC Frequency data
EEPROM
Factory adjustment data of
VA-226 board
Adjustment/setup upon
replacement of EEPROM/FRAM
Refer to Section 1-10-7.
Refer to Section 1-10-6.
*1
Refer to Section 1-10-5.
1-15 (E)