Replacing The Menu Select Knob/Menu Switch/Display Switch; Bvp-E30/E30P M-V1 - Sony BVP-E30 Maintenance Manual

2-6. Replacing the MENU SELECT Knob/
MENU Switch/DISPLAY Switch
1. Remove the V shoe bracket. (Refer to Section 2-5.)
2. Remove the MENU SELECT knob.
3. Remove the two screws, and remove the switch block
with the two harnesses connected to the CN-2205
board.
n
The drop protection pad will remove at the same time.
Be careful not to lose it.
4. Disconnect the two harnesses from the connectors
CN1005 and CN1004 of the CN-2205 board.
CN-2205 board
MENU SELECT
knob
P2.6 x 5
CN1005
CN1004
2-10 (E)
Drop protection
pad
Switch block
P2.6 x 5
5. Remove the screw securing the SW-1069 board to the
encoder bracket, and remove the SW-1069 board.
6. Desolder the switch to be replaced, and replace it.
7. Remove the nut fixing the MENU SELECT knob, and
remove the SW-1070 board.
8. Desolder the rotary encoder (MENU SELECT knob),
and replace it.
Encoder bracket
Projection
Washer
Nut
Rotary encoder
(MENU SELECT knob)
9. Reassemble the parts in the reverse order of removal.
n
When installing the SW-1069 board, put the projection
of the encoder bracket into the hole of the SW-1069
board surely.
B2.6 x 5
Hole
SW-1069 board
SW-1070 board

BVP-E30/E30P M-V1