Upgrading Main Program; Upgrading Boot Program; Bvp-E30/E30P M-V1 - Sony BVP-E30 Maintenance Manual

1-11. Upgrading the Software
The version of the MAIN program and BOOT program can
be upgraded using the memory stick. According to neces-
sary, follow the procedures shown below.
m
. The upgrading program must have already been saved in
a memory stick before.
. Refer to Section 5-1-6 to display of the SERVICE menu.
. Refer to Section 3-1 for the basic operations of the setup
menu.

1-11-1. Upgrading MAIN Program

When the Setup Menu is Used for Version
Upgrading
1. Insert the memory stick in which the upgrading
program is already saved.
2. Display the FIRM UPDATE page of the SERVICE
menu, and execute the MAIN PROGRAM.
3. The upgrading status is displayed on the viewfinder
screen.
4. When the version upgrade is completed, the message
"Complete" will be displayed.
n
When the tally switch on the camera adaptor is set to
ON, the tally lamp will blink during being upgrading,
and then light up when upgrading is completed.
5. Restart the unit, and confirm the version indication
using DIAGNOSIS menu.

BVP-E30/E30P M-V1

Upgrading by Powering ON the Unit
1. Insert the memory stick in which the upgrading
program is already saved.
2. Turn on the power while pressing the VTR START
switch and MENU SELECT knob on the camera front
simultaneously.
3. The upgrading status is displayed on the viewfinder
screen.
4. When the version upgrade is completed, the message
"Complete" will be displayed.
n
When the tally switch on the camera adaptor is set to
ON, the tally lamp will blink during being upgrading,
and then light up when upgrading is completed.
5. Restart the unit, and confirm the version indication
using DIAGNOSIS menu.

1-11-2. Upgrading BOOT Program

BOOT program is a software renewing the firmware using
the memory stick. Do not operate this program except
upgrading the program.
1. Insert the memory stick in which the upgrading
program is already saved.
2. Display the FIRM UPDATE page of the SERVICE
menu, and execute the BOOT PROGRAM.
3. When the version upgrade is completed, the message
"Complete" will be displayed.
n
When the tally switch on the camera adaptor is set to
ON, the tally lamp will blink during being upgrading,
and then light up when upgrading is completed.
1-17 (E)