Replacing The Coaxial Cable With Connector (Fine Pitch Coaxial Cable) - Sony PMW-EX1 Service Manual

1-10. Replacing the Coaxial Cable with
Connector (Fine Pitch Coaxial Cable)
The PWM-EX1 uses coaxial cables with connector.
The following precautions must be observed when remov-
ing or connecting the coaxial cable with connector.
Note on Disconnecting
The coaxial cable with connector uses fine pitch coaxial
cables. Be careful when arranging the cable. When discon-
necting the coaxial cable with connector, do not attempt to
remove by pulling the cable. Be sure to hold the connector
to remove.
OK Hold the connector to remove.
Do not attempt to remove by pulling
NG
the cables.
PMW-EX1
Note on Connecting
. Do not insert the coaxial cable with connector at an
angle.
. Check that the contact on the coaxial cable with connec-
tor is free from dirt or dust.
. Always insert the coaxial cable with connector with the
contact surface up.
. When connecting the coaxial cable with connecor, hold
the connector, and align the polarity marks. Then
connect the coaxial cable wih connector to the connector
straight.
Contact
surface
Hold the connector to connect.
OK
Not to bend the cable.
NG
Polarity marks
1-15