2-1. Replacing the CCD Block and
Component Parts
2-1-1. Replacing the CCD Unit
n
Filter disk unit and the DR-536 board are not attached to
CCD unit for repair of the BVP-E30/E30WS/E30WSP.
Install the removed filter disk unit into a new CCD unit.
1. Remove the right and left side panels.
(Refer to Section 1-5.)
2. Remove the four screws, and remove the DPR-261
board.
MB-953 board
DPR-261 board
B2.6 x 5
B2.6 x 5
BVP-E30/E30P M-V1
Section 2
Replacement of Main Parts
3. Disconnect the two flexible card wires from the
4. Remove the four screws with stopper, and remove the
CN6 (blue)
connectors CN2 and CN3 of the MB-953 board, and
three harnesses from the connectors CN4 (red), CN5
(yellow) and CN6 (blue).
n
Be careful not to bend the flexible card wires.
This shortens the wire life.
CCD block.
CN5 (yellow)
CN4 (red)
MB-953
board
CN2
CN3
CCD block
CN4
R
Red
CN5
G
Yellow
CN6
B
Blue
Screws with stopper
Screws with stopper
2-1 (E)