Replacing The Boards Inside The Ccd Unit; Bvp-E30/E30P M-V1 - Sony BVP-E30 Maintenance Manual

2-1-3. Replacing the Boards Inside the CCD
Unit
Remove the CCD block first from the camera, and perform
the following steps.
(Refer to Section 2-1-1.)
n
Be careful not to bend the flexible card wires.
This shortens the wire life.
BVP-E30/E30WS/E30WSP
1. Removing the filter disk unit
m
. At removal and installation, do not touch the surfaces of
the filter.
. When replacing the filter disk unit, replace the DR-536
board together.
(1) Disconnect the harnesses from the connectors CN2 of
the DR-536 board.
(2) Remove the two screws.
4
B2.6 x 4
B2.6 x 4
CN3
B2.6 x 4
CN4
5
K3 x 6
2-4 (E)
1
Precision
P2 x 5.0
2. Removing the DR-536 board
(1) Disconnect the flexible card wire.
(2) Remove the three screws.
3. Removing the NR-72 board
(1) Disconnect the flexible card wires from the connectors
CN1 and CN2 of the NR-72 board.
(2) Remove the two nylon rivets and three screws.
4. Removing the TG-229 board
(1) Disconnect the flexible card board (CN-2148 board)
from the connectors CN3 and CN4 of the TG-229
board.
(2) Remove the three screws.
5. Removing the flexible card board (CN-2148
board)
Disconnect the flexible card board (CN-2148 board) from
the connector CN1 of the PA-272/273/274 board.
6. Installing
Install a new board in the reverse order of steps 1 to 5.
Nylon rivet
B2.6 x 4
CN1
CN2
Precision
P2 x 5.0
2
Nylon rivet
B2.6 x 4
B2.6 x 4
3
CN1
B2.6 x 4

BVP-E30/E30P M-V1