2-11. Replacing the MIC Connector
1. Remove the V shoe bracket. (Refer to Section 2-5.)
2. Disconnect the harness from the connector CN1002 of
the CN-2205 board.
3. Remove the two screws, and remove the MIC connec-
tor with harness.
4. Desolder the MIC connector, and replace it.
CN-2205 board
CN1002
MIC connector
K2.6 x 6
5. Reassemble the parts in the reverse order of removal.
BVP-E30/E30P M-V1
2-12. Replacing the DC-DC Converter
1. Remove the right side panel. (Refer to Section 1-5.)
2. Remove the two screws, and remove the DC-DC
converter (RE-201 board) while pushing it up in the
arrow direction, and replace it with a new one.
MB-953 board
3. Reassemble the parts in the reverse order of removal.
DC-DC converter
(RE-201 board)
P2.6 x 5
2-13 (E)