Presetting Compensation Data; Service Menu; Bvp-E30/E30P M-V1 - Sony BVP-E30 Maintenance Manual

5-1-5. Presetting Compensation Data

Before beginning adjustment of board, preset all compensation data output from the CPU. To preset
proceed as follows. By presetting the data, the CPU will output the center value of each data. If you adjust
each item without presetting, it cannot be regarded as completion of adjustment.
How to preset the data
Perform the preset operation on the camera using the viewfinder displays.
n
Make sure the no display appears on the viewfinder before beginning presetting.
Use the DISPLAY switch on the side panel of the camera and the MENU SELECT knob on the front
panel to preset.
1. Set the DISPLAY switch from OFF to MENU while holding down the MENU SELECT knob.
The TOP menu appears in the viewfinder.
2. Select the FILE menu and display the REFERENCE page.
3. Select ALL PRESET and execute presetting. When presetting is normally executed, a message
"Completed" is displayed.
4. Return the DISPLAY switch to OFF.

5-1-6. SERVICE Menu

In this section, the SERVICE menu is used to perform adjustment.
To display the SERVICE menu, follow the procedure below.
1. Set the DISPLAY switch to MENU.
2. Double-click the ASSIGNABLE switch while setting the STATUS/CANCEL switch to STATUS.
In this section, the menu operations are described as follows:
Example : When selecting ENC of TEST OUT at the VA TRIMMING page of the SERVICE menu.
MENU : SERVICE
PAGE : VA TRIMMING
TEST OUT → ENC
ITEM :
5-4 (E)

BVP-E30/E30P M-V1