5. Disconnect the harness from the connector CN801 of
the SW-1071 board.
6. Disconnect the harness from the connector CN18 of
the MB-953 board.
7. Remove the three screws, and remove the handle
holder.
Handle holder
B3 x 5
MB-953 board
CN18
8. Remove the two screws, and remove the bracket
(SW-1071).
Handle holder
B2.6 x 5
2-8 (E)
B4 x 8
SW-1071 board
CN801
Bracket
(SW-1071)
9. Remove the two screws, and remove the SW-1071
board.
n
When removing, do not lose the CC switch cover.
10. Desolder the ASSIGNABLE switch, and replace it.
ASSIGNABLE switch
B2.6 x 5
SW-1071 board
11. Install the SW-1071 board to the bracket (SW-1071)
with the two screws.
m
. Put the tip of the ASSIGNABLE switch into the
CC switch cover.
. Put the tip of the CC switch cover at the center of
the hole on the handle holder.
. Push the CC switch cover, and check the click sound
that the switch clicks when pushing ON/OFF.
12. Reassemble the parts in the reverse order of steps 1 to
8.
n
When installing the handle holder, make sure the
harnesses are routed properly and are not caught
between the handle holder and the chassis.
Bracket
(SW-1071)
CC switch cover
CC switch cover
Handle holder
BVP-E30/E30P M-V1