Replacement Of Main Parts; Replacing The Main Parts; Camera Block Assembly - Sony BRC-Z700 Service Manual

2-1. Replacing the Main Parts

Tool/parts information
Tool
When removing the tilt gear and bottom block, use the
following tool.
. Part name: Reserved stand tool
Reserved stand tool (reference)
. Part name:
Tool, KANIME (tilt)
Part number: J-6433-530-A
Parts information
Two types of screw (PSW2.6 x 6) are used in this unit.
. Part number: 3-986-877-01
+PSW2.6 x 6
Part name:
. Part number: 7-621-759-40
+PSW2.6 x 6
Part name:
n
In the illustration of this section, this screw is described
as PSW2.6 x 6 (large).
. Part name:
Tape (A)
Part number: 3-080-272-01
n
Replace the removed tape (A) with the new tape (A).
BRC-Z700
Section 2

Replacement of Main Parts

2-1-1. Camera Block Assembly

Precaution for replacement
After replacing the camera block assembly, do not turn on
the power before attaching the cover of the camera block
assembly. The light shielding processing is not applied to
the side of the prism block of the camera block assembly.
Because of this, if you turn on the power without attaching
the cover of the camera block assembly after it is replaced,
the light enters the side of the prism portion, which causes
the overexposure (whiteout condition) of the output image.
When the power is turned on, the subsequent defect of the
imager is checked. If the power is turned on in the above
state (light entering the side of the prism without cover), it
may cause an erroneous judgment. If it is required to turn
on the power for checking the assembly (wiring) and so on
after replacing the camera block assembly, perform the
following before turning on the power.
. Attach the cover to the camera block.
. Cover with the light shield without applying force on the
fixing portion of the imager.
2-1