Video Send_Commands; Vi<Input>O<Output; Vidin_Auto_Select; Audout_Mute - AMX SDX-510M-DX Instruction Manual

Audio SEND_COMMANDs (Cont.)

AUDOUT_MUTE

CI<input>O<output>

Video SEND_COMMANDs

The following table lists the video SEND_COMMANDs available for the SDX Digital Media Switchers:
Video SEND_COMMANDs
VI<input>O<output>

?VIDIN_AUTO_SELECT

VIDIN_AUTO_SELECT
Instruction Manual - Solecis Digital Switchers
Enable or disable audio muting on the ports specified by AUDOUT_FORMAT. The mute
state works as follows:
Setting: AUDOUT_MUTE = ENABLE
AUDOUT_FORMAT - HDMI (HDMI audio muted, DXLINK audio off)
AUDOUT_FORMAT - DXLINK (HDMI audio off, DXLINK audio muted)
AUDOUT_FORMAT - ALL (HDMI audio muted, DXLINK audio muted)
Setting: AUDOUT_MUTE = DISABLE
AUDOUT_FORMAT - HDMI (HDMI audio plays, DXLINK audio off)
AUDOUT_FORMAT - DXLINK (HDMI audio off, DXLINK audio plays)
AUDOUT_FORMAT - ALL (HDMI audio plays, DXLINK audio plays)
Syntax:
SEND_COMMAND <DEV>,"'AUDOUT_MUTE-<ENABLE|DISABLE>'"
Example:
SEND_COMMAND dxDev,"'AUDOUT_MUTE-DISABLE'"
Switches both the audio and video input to the output port.
Syntax:
SEND_COMMAND <DEV>, "'CI<input>O<output>'"
Variables:
input = The source input port number.
output = The output port number to use.
Examples:
SEND_COMMAND SWITCHER,"'CI2O1'"
Switches (audio/video) input port #2 to output #1.
Switch input to one or more outputs for switcher level Video. Set <input> to 0 to send audio
with no video.
Note: This command is only compatible with the SDX-510M-DX.
Syntax:
SEND_COMMAND <DEV>, "'VI<input>O<output>'"
Variables:
input = The source video input port number.
output = The video output port number to use.
Example:
SEND_COMMAND SWITCHER,"'VI2O1'"
Switch video input port #2 to video output #1.
Requests setting for the Auto Select mode for the video input signal on the switcher.
Syntax:
SEND_COMMAND <DEV>, "'?VIDIN_AUTO_SELECT'"
Example:
SEND_COMMAND VIDEO_INPUT_1,"'?VIDIN_AUTO_SELECT'"
Returns a COMMAND string of the form: VIDIN_AUTO_SELECT-<status>.
Enables or disables the Auto Select mode for the video input signal on the switcher. This
feature is enabled by default.
Syntax:
SEND_COMMAND <DEV>,"'VIDIN_AUTO_SELECT-<ENABLE|DISABLE>'"
Example:
SEND_COMMAND VIDEO_INPUT_1,"'VIDIN_AUTO_SELECT-ENABLE'"
Programming
41