Get Friendly; Get Ip; Get Location; Get Sn - AMX SDX-510M-DX Instruction Manual

Appendix A - Telnet (Terminal) Commands
Telnet Commands (Cont.)
Command

GET FRIENDLY

GET IP

GET LOCATION

GET SN

MSG [ON|OFF]

NDP UNBIND

PING [ADDRESS]

REBOOT

RENEW DHCP

RESET FACTORY

50
Description
Displays the device's friendly name (for NDP).
Displays the IP configuration of a device.
The device displays its D:P:S, Host Name, Type (DHCP or Static), IP Address, Subnet
Mask, Gateway IP, and MAC Address.
Example:
>GET IP
HostName SDX-510-000-EXB
Type DHCP
IP Address 192.168.43.63
Subnet Mask 255.255.255.0
Gateway IP 192.168.43.2
MAC Address 00:60:9f:99:26:f1
[[also displays "Lease" details; see example for GET CONFIG
command]]
Displays the location parameter for NDP, which is set by using the SET LOCATION
command (see page 52).
Returns the device's serial number.
Enables/Disables extended diagnostic messages.
• MSG ON [error|warning|info|debug] sets the terminal program to display log messages
generated by the Master. The level of log printed to the terminal window depends both
on the level used when sending the message and the output level selected with "msg
on."
For example if log output is enabled via "msg on warning" then logs produced at levels
AMX_ERROR and AMX_WARNING will be displayed, but not logs produced at levels
AMX_INFO or AMX_DEBUG.
The order of severity from highest to lowest is ERROR, WARNING, INFO, DEBUG.
If no severity is supplied with "msg on," the default setting is WARNING.
• MSG OFF disables the display.
Example:
> MSG ON
Extended diagnostic information messages turned on.
> MSG OFF
Extended diagnostic information messages turned off.
Clears the NDP binding to a Master (takes effect after next boot).
Pings an address (IP or URL), to test network connectivity to and confirms the
presence of another networked device.
The syntax matches the PING application in Windows or Linux.
Example:
>ping 192.168.29.209
192.168.29.209 is alive.
Reboots the switcher.
Example:
>REBOOT
Rebooting...
Renews/releases the current DHCP lease for the switcher.
Note: Because sending this command can result in the unit acquiring a new DHCP
address and the functionality of the endpoints is dependent on the mated IP addresses of
the TX (host) and RX (device), the USB connection may need to be re-established.
Example:
>RENEW DHCP
Resets the device's stored parameters to factory default state including removal of all
security settings, resetting to DHCP.
This command will cause an automatic reboot.
Note: This command does not reset the device to the factory software image.
Instruction Manual - Solecis Digital Switchers