Mounting The Switcher On A Pole; Mounting The Switcher On A Rack Shelf - AMX SDX-510M-DX Instruction Manual

Mounting the Switcher on a Pole

The AVB-VSTYLE-POLE-MNT, V Style Single Module Pole Mounting Kit (FG1010-723) is designed for mounting a
single module to a projector pipe (or other 2 inch diameter pipes). The kit contains all the mounting hardware for the
assembly in FIG. 33.
Perform these steps to mount the switcher on a pole:
1.
Attach the mounting brackets to the module according to the instructions for surface mounting (see FIG. 28).
2.
Insert the first u-bolt around the pole/pipe and through the bracket and plate according to FIG. 33.
3.
Fasten securely with the hex nuts.
4.
Repeat Steps 2 and 3 using the remaining u-bolt, bracket, plate, and hex nuts.
FIG. 33 Mount to projector pipe with bolts through brackets

Mounting the Switcher on a Rack Shelf

You can mount the switcher on a rack shelf by using an NMX-VRK V-Style Rack Shelf (FG3201-60). In addition to the
switcher, you can also use wire ties to mount the switcher's power supply on the rack shelf.
FIG. 34 NMX-VRK V-Style Rack Shelf
Perform these steps to mount the encoder using the NMX-VRK Rack Shelf:
1.
Invert the switcher and the rack shelf for ease of installation.
2.
Attach the rack shelf to the bottom of the switcher using the #4-40 3/16 inch undercut flat head screws (provided).
Insert the screws through the underside of the rack shelf and into the holes on the bottom of the switcher. Note that
only two screws are required.
3.
Install the rack shelf in a standard EIA 19 in. (48.26 cm) rack and secure with rack-mounting screws.
Instruction Manual - Solecis Digital Switchers
Installation
29