AMX SDX-510M-DX Instruction Manual page 14

Overview
SDX-510M-DX Specifications (Cont.)
Active Power Requirements:
Voltage, AC (Typical):
Power Consumption
(Max):
Power Connector:
DXLink Power:
Power Supply:
Internal, Included
Environmental:
Temperature
(Operating):
Temperature (Storage):
Humidity (Operating):
Humidity (Storage):
USB (HID) Keyboard and Mouse:
USB (HID)
Front Connectors:
ID Pushbutton:
AxLink Keypad Control: (1) 4-pin, 3.5mm Screw Terminal Connector
Ethernet LAN OUT:
HDMI Output:
DXLink Output:
USB Host Port:
USB Device Port:
Back Connectors:
Advanced
Configuration Interface:
HDMI Inputs:
VGA Inputs:
Single External Button/
LED Control Connector:
Dual External Button/
LED Control Connector:
Analog Stereo Inputs:
AC Power Connection:
Ethernet:
Ethernet Connections:
Ethernet Link/Act
Indicator:
Ethernet Speed
Indicator:
6
110-240VAC, 47-63 Hz
48 W
IEC Power Cord Connector 100-240 VAC 47-63 Hz
Supplies power to a DXLink Twisted Pair RX, when used in point-to-point applications
Yes
32° F to 104° F (0° C to 40° C)
-22° F to 158° F (-30° C to 70°C)
5% to 85% non-condensing
0% to 90% non-condensing
(1) USB Type Connector ("TO HOST"); connect a Solecis Digital Switcher with DXLink to a PC
and emulate keyboard and mouse commands from a DXLink Receiver
(1) ID Pushbutton, can be used to assign the unit's Device ID, switch between Static and
Dynamic IP addressing modes, and reset the unit to factory defaults.
(3) RJ-45 Connectors
(1) HDMI Type A Female Connector
(1) RJ-45 Connector
(1) USB Type B Connector "TO HOST"
(1) USB Type A Connector, reserved for future use
(1) USB Mini-B Connector
(3) HDMI Type A Female Connectors
(2) HD-15 Connectors
(1) 3-pin, 3.5mm Screw Terminal Connector
(2) 5-pin, 3.5mm Screw Terminal Connectors
(2) 1/8" mini-Stereo Jack
IEC Power Cord Connector
(3) RJ-45, 10/100 Port provides TCP/IP communication. This is an Auto MDI/MDI-X enabled
port, which allows you to use either straight-through or crossover Ethernet cables. The
Ethernet Port LEDs show communication activity, connection status, speeds, and mode
information.
(1) Link/Activity LED (green) blinks when receiving Ethernet data packets, one on Ethernet
RJ-45 connector and one on the front panel.
(1) Speed LED (yellow) lights On when the connection speed is 100 Mbps Ethernet connection
and turns OFF when the speed is 10 Mbps
Instruction Manual - Solecis Digital Switchers