Axlink Port And Led (4-Pin Captive-Wire) - AMX Enova DVX-3150HD-SP Instruction Manual

FIG. 53 provides the pinouts and signals for the LAN connector and cable.
RJ-45 Wiring Diagram
FIG. 53
FIG. 54 describes the blink activity for the LAN connector and cable.
L/A - Activity LED (green)
lights when receiving or
transmitting LAN
LAN Connector / LEDs
FIG. 54

AxLink Port and LED (4-pin captive-wire)

The AxLink port (FIG. 55) allows the DVX to support AMX AxLink devices.
FIG. 55 displays the AxLink port and LED.
AxLink Port and LED
FIG. 55
The (green) AxLink LED indicates AxLink data activity:
Off - No power, or the controller is not functioning properly.

1 blink per second - Normal operation.

3 blinks per second - AxLink bus error. Check all AxLink bus connections.

The AxLink port can be used to supply power to downstream AxLink-compatible devices as long as the maximum current draw is
less than 1 Amp. To isolate the DVX from high inrush current, AxLink devices, or potential power faults on the AxLink bus, it is
strongly recommended that you power external AxLink devices from an independent power supply.
NOTE: The AxLink port provides only limited power to connected AxLink devices. It is recommended to use an alternate power source
when connecting AxLink devices to the DVX.
When using the DVX with the NXA-PDU-1508-8 power distribution unit, do NOT connect +12V power from any of the NXA-PDU's
AxLink ports to the AxLink power pin.
Refer to the following table for the wiring length information used with the DVX:
Wiring Guidelines
Wire size
18 AWG
20 AWG
22 AWG
24 AWG
Enova DVX-315xHD & DVX-215xHD All-in-One Presentation Switchers - Instruction Manual
A
data packets
Maximum wiring length
154.83 feet (47.19 meters)
98.30 feet (29.96 meters)
63.40 feet (19.32 meters)
38.68 feet (11.79 meters)
L
SPD - Link LED (amber) lights when
the LAN cables are connected
and terminated correctly.
Wiring and Device Connections
43