Table of Contents
Advertisement
5-4
Section 5 Disassembly and Reassembly
3.
Pull the panel away from the chassis.
Side Panel Removal
Remove the side panel from the system unit as follows.
Remove the system access cover and front panel as previously described.
1.
Locate the two side panel securing tabs at the front of the system.
2.
3.
Pull the tabs out and away from the system.
4.
Slide the side panel towards the rear of the unit and away from the unit.
Device Cage Removal
Remove the device cage from the system unit as follows.
Label and disconnect any cables connected to devices in the device cage.
1.
2.
Locate the screw on the front of the system between the 3.5-inch blank panel and
diskette drive (see Figure 5-3). Remove the screw.
3.
Slide the cage towards the front of the system and lift it out of the unit.
Diskette Drive Removal
Remove the standard diskette drive from the system unit as follows.
Remove the system access cover and front panel as previously described.
1.
Figure 5-3 Locating the Device Cage Screw
Advertisement
Table of Contents
Troubleshooting
