Confirming The Remaining Capacity On The Memory; Label; Clearing Recorded Data - Sony HDW-790P Operation Manual

3-4-4 Confirming the Remaining
Capacity on the Memory Label
1
Follow steps 1 to 3 in "Setting the Tele-File mark to be
recorded for the first time after power on" (page 53) to
display the TELE FILE page of the FILE menu.
The remaining capacity of the memory label is displayed
on the REMAIN line.
You can record the recording start time code about 130
times on a memory label with a capacity of 1 Kilobyte.
Note
When the remaining capacity of the memory label reaches
0%, you cannot record the recording start time code any
more. "0%" is displayed on the REMAIN line and the
message "MEMORY FULL" is displayed on the STATUS
line.

3-4-5 Clearing Recorded Data

1
Follow steps 1 to 3 in "Setting the Tele-File mark to be
recorded for the first time after power on" (page 53) to
display the TELE FILE page of the FILE menu.
2
Turn the MENU knob to move the
FILE CLEAR, then push the MENU knob.
The message "CLEAR DATA OK? YES NO" appears.
b
In this case, the mark is displayed next to "NO" and
"NO" blinks.
3
Turn the MENU knob to move the
("YES" blinks), then push the MENU knob.
The data recorded on the memory label is cleared.
100 % appears on the REMAIN line.
Notes
• When the memory label is protected from accidental
erasure, you cannot clear recorded data.
• The time code data is cleared. However, the memory
label ID is not affected.
b
mark to TELE
b
mark to YES
Recording the Recording Start Time Code onto the Memory Label — Tele-File
55