Table of Contents
Advertisement
(4) Testing the earphone and speaker
1
Turn the MONITOR volume control and check that the
speaker volume changes accordingly.
2
Connect an earphone to the front or rear EARPHONE
jack.
Check that the speaker sound is cut off and that you
can hear the sound from the microphone in the
earphone.
3
Turn the MONITOR volume control and check that the
earphone volume changes accordingly.
4
Connect the earphone to the other EARPHONE jack.
Check the earphone as in step 3.
(5) Testing external microphones.
1
Set the LINE / AES/EBU / MIC selector that
corresponds to the channel to which the external
microphone will be connected in step 2 to MIC and set
the +48 V/OFF switch as follows.
• If the connected microphone has an internal power
supply, set the switch to OFF.
• If the connected microphone has an external power
supply, set the switch to +48V.
2
Connect an external microphone to either the AUDIO
IN CH1 or AUDIO IN CH2 connector.
3
Set the AUDIO IN switch that corresponds to the
channel to which the external microphone is connected
to REAR.
4
Aim the microphones at a sound source.
5
Check that the audio level meter in the display panel
and the audio level indicators in the viewfinder reflect
the changing sound level.
(6) Checking the user bit and time code
functions
1
Set the user bits as required.
For the operation, see "4-5-3 Setting the User Bits" on
page 71.
2
Set the time code.
For the operation, see "4-5-1 Setting the Time Code"
on page 70.
3
Set the F-RUN/SET/R-RUN switch to R-RUN.
134
Testing the Camcorder Before Shooting
4
Press the VTR START button, and check that
recording starts and that the counter indication
changes.
5
Press the VTR START button again, and check that the
tape stops and that the counter indication also stops
changing.
6
Set the F-RUN/SET/R-RUN switch to F-RUN, and
check that the counter indication changes regardless of
whether the tape is running.
7
Set the DISPLAY switch to DATA and the DATA
DISPLAY switch to U-BIT, and check that the user bit
data that was set is displayed.
Advertisement
Table of Contents
