Table of Contents
Advertisement
No.
Page
Item
M05
BATTERY
BEFORE END 1
END 1
BEFORE END 2
END 2
BEFORE END 3
END 3
M06
AUDIO-1
AUDIO OUT (F/R)
REC AUDIO OUT
CAMERA
ADAPTER
AUDIO CH3/4
MODE
FRONT MIC REF
REAR MIC REF
REAR MIC +48V
REC AUDIO DELAY OFF/1 FLD
Settings
Default
5/10/15 to 95/100%
5%
(in 5% steps)
0/1/2/3/4/5%
0%
11.0 to 17.0 V
11.3
(in 0.1 V steps)
10.5 to 11.5 V
11.0
(in 0.1 V steps)
11.0 to 17.0 V
11.8
(in 0.1 V steps)
10.5 to 14.0 V
11.0
(in 0.1 V steps)
CUE/EE
CUE
EE/SAVE
EE
ENABL/DSABL
ENABL
CH1/2/SW
SW
–60 dB/–50 dB/–40
–50 dB
dB
–60 dB/–50 dB/–40
–60 dB
dB
ENABL/DSABL
ENABL
OFF
Description
Used when a Sony-made battery pack, such
as a BP-GL65/GL95, is used. Sets the
voltage warning level just before the battery
ends.
Used when a Sony-made battery pack, such
as a BP-GL65/GL95, is used. Sets the
voltage level at which the battery ends and
the camcorder stops operation, just before
the battery ends.
Used when a Sony-made battery pack, such
as a BP-L60S, is used. Sets the voltage
warning level just before the battery ends.
Used when a Sony-made battery pack, such
as BP-L60S, is used. Sets the voltage level at
which the battery ends and the camcorder
stops operation, just before the battery ends.
Used when a battery pack other than a Sony-
made one or an external power connected to
the DC IN connector is used. Sets the voltage
warning level just before the battery ends.
Used when a battery pack other than a Sony-
made one or an external power connected to
the DC IN connector is used. Sets the voltage
level at which the battery ends and the
camcorder stops operation, just before the
battery ends.
Selects the audio output signal during FF/
REW.
CUE: cue audio signal
EE: Input signal
Selects the audio output signal during
recording.
EE: Input signal
SAVE: Not output
When a camera adaptor is connected, selects
whether or not to enable input of audio
channels 3 and 4 from the camera adaptor.
ENABL: Camera adaptor can be used.
DSABL: Camera adaptor cannot be used.
Selects the sources to be recorded on
channels 3 and 4.
CH1/2: Same sources as channels 1 and 2.
SW: Signals selected by the AUDIO IN CH-3/
CH-4 switches.
Sets the reference level of the front
microphone.
Sets the reference level when the AUDIO IN
CH1 or CH2 connector is set to MIC.
Selects whether external power is supplied to
the external microphone when AUDIO IN
CH1 or CH2 connector is set to MIC.
Sets the audio recording phase.
OFF: Audio is recorder in the same phase as
the video.
1 FLD: Audio is recorded in the phase
delayed from the video by one field.
157
Menu List
Advertisement
Table of Contents
