Yamaha XC125 Service Manual page 68

ENGI 1
ENGINE ASSEMBLY AND ADJUSTMENT
: " :_:::_ :.-::_ ....... 1. Install:
- Crankshaft with gear(_)/Balancer (_)
NOTE:
Align the mark on the balancer gear (_ with the
-- mark on the crankshaft gear (_ .
2. Install:
. Oil pump assembly (_)
_mp Body):
]
7 Nm (0.7 m.kg, 5.1 ft.lb) /
_11_ _)//_ - Oil pump drive shaft (_
• Spring pin (_)
= Driven gear (_)
,>_
..( ' ,,_..._//(_ %,,.
-Spacer
__ (_ Oil pump body plate
(_ Oil pump idler gear
(_ Idle gearshaft
3. Apply:
e Quick Gasket_ (ACC-11001-05-01)
,_ (to the mating surfaces)
; _ 4. Install:
| . Dowel pins(_)
5. Install:
...... _ __ • Crankcase (Right)
Tap the crankcase on lightly using a Soft
Hammer.
6. Tighten:
• Bolts (Crankcase)
Bolts (Crankcase):
10 Nm (1.0 m.kg, 7.2 ft.lb)
NOTE:
Tighten the bolt using crisscrosspattern.
®
3-29