Yamaha XC125 Service Manual page 107

F.ONT ORKSANO STEER NO.EAO
Do not over-tightening.
Ring Nut (Lower):
30 Nm (3.0 m. kg, 22 ft. Ib)
• Loosen the ring nut (lower) 1/4 turn.
• Hold the ring nut (lower), and tighten the
ring nut (upper)using the Ring Nut Wrench.
NOTE:
Set the Torque Wrench to the Ring Nut
Wrench so that they form a right angle.
Do not over-tightening.
Ring Nut (Upper):
30 Nm (3.0 m. kg, 22 ft. Ib)
• Check the smooth operation of the steering
shaft, and readjust it as required.
z. _ _:_ 7. Install:
,_;" e Handlebar assembly
8. Tighten:
• Bolt (Handlebar mounting) (_)
_Mounting) :
•kg, 24 ft. Ib) I
NOTE"
Take care for handlebar-front wheel alignment.
9. Continue Assemble; Reverse the dis-
assembly procedures and note the follow-
ing points.
= Check for smooth throttle operation and
quick spring return. Make certain that the
housing does not rotate on the handlebar.
• Before installing the leg shield, check for
electrical component operations.
® Adjust the front brake for free play and
operation. Refer to "CHAPTER 2.
FRONT BRAKE ADJUSTMENT"
section.
5-12