Enable Ipsec - Oce PlotWave 750 Operation Manual

Enable IPSec

Introduction
[IPsec] is a security protocol that you can use:
• To limit access to your network to a maximum of 5 hosts.
• To encrypt the data between the hosts and the system.
NOTE
You can enable [IPsec] in Océ Express WebTools via the printer controller monitor or via any
other networked workstation. For more information on [IPsec], consult the Océ PlotWave -
ColorWave Systems Security Manual.
NOTE
You can only disable [IPsec] in Océ Express WebTools via the printer controller or via one of the
identified hosts.
NOTE
Make sure your [IPsec] configuration is correct. You may not be able to connect to the printer as
a result of an invalid [IPsec] configuration. In such cases, you can disable [IPsec] on the
controller ([Configuration] - [Connectivity] - [IPsec generic]).
Procedure
1.
Open Océ Express WebTools and log in as [System administrator].
2.
Open the [Configuration] - [Connectivity] tab.
3.
Go to the [IPsec generic] bar.
4. Click on Edit in the upper right-hand corner of the section.
5. Change the [IPsec] setting from [Disabled] to [Enabled].
NOTE
[Enable or disable IPsec. IPsec restricts access to the printer over IPv4. It also encrypts the
communication between the hosts and the printer. Note that when IPv6 is enabled also, traffic
over IPv6 is not restricted, nor encrypted.]
Enable or disable the failsafe option
Procedure
1.
Open Océ Express WebTools and log in as [System administrator].
2.
Open the [Configuration] - [Connectivity] tab.
3.
Go to the [IPsec generic] bar.
4.
Click on Edit in the upper right-hand corner of the section.
5.
Choose the setting for the [Failsafe option]; select either [Disabled] or [Enabled].
NOTE
[When enabled, HTTP communication remains possible with all hosts, with no encryption, even
when IPsec is enabled. All functionality of Express WebTools, including job submission, uses
HTTP. Once IPsec is configured correctly and working satisfactorily, this option can be disabled. ]
Chapter 3 - Define your workflow with Océ Express WebTools
Enable IPSec
109