KYMCO PEOPLE S 125 Service Manual page 54

4
. LUBRICATION SYSTEM
ASSEMBLY
Install the outer rotor, inner rotor and pump
shaft into the pump body.
＊
Insert the pump shaft by aligning the flat
on the shaft with the flat in the inner
rotor.
Install the dowel pin.
Install the pump cover by aligning the hole in
the cover with the dowel pin.
Tighten the screw to secure the pump cover.
Make sure that the pump shaft rotates freely
without binding.
INSTALLATION
Install the oil pump into the crankcase.
＊
Install the oil pump with the arrow on the
pump body facing up and fill the oil pump
with engine oil before installation.
After the oil pump is installed, tighten the two
mounting bolts.
4-7
Inner Rotor
Outer Rotor Dowel Pin
Screw
Oil Pump
Bolts
PEOPLE S 4T
Screw
Pump Cover
Arrow