KYMCO PEOPLE S 125 Service Manual page 184

17
. LIGHTS/INSTRUMENTS/SWITCHES
SERVICE INFORMATION
GENERAL INSTRUCTIONS
• An electric tester is needed to measure or test the electric equipment.
• Be sure to use fuses and bulbs of the same specifications to avoid damage of electrical
equipment.
• After installation of each switch, a continuity check must be performed. A continuity check can
usually be made without removing the part from the motorcycle.
TROUBLESHOOTING
Lights do not come on and horn does not
sound when ignition switch is "ON"
• Faulty ignition switch
• Fuse burned out
• Weak battery
• Burned bulb
• Faulty switch
• Faulty horn
• Poorly connected, broken or shorted wire
Fuel gauge pointer does not move
• Faulty fuel gauge
• Faulty fuel unit
• Poorly connected, broken or shorted wire
Engine starts but stalls during idling
•Faulty auto bystarter
• Faulty auto bystarter resistor
• Poorly connected or broken wire
• Clogged carburetor
Fuel gauge pointer does not register
correctly
• Faulty fuel gauge
• Faulty fuel unit
• Faulty fuel unit float
PEOPLE S 4T
17-2