17
. LIGHTS/INSTRUMENTS/SWITCHES
INSPECTION
Measure the resistance between the fuel unit
wire terminals with the float at upper and
lower positions.
RESISTANCES
Float
Color
G~Y/W
The installation sequence is the reverse of
removal.
*
• Install the fuel unit on the connect
position.
AUTO BYSTARTER
AUTO BYSTARTER INSPECTION
Remove the body cover. ( 2)
Disconnect the auto bystarter wire connector.
Measure the resistance between the yellow
and green/black wire terminals.
Resistance: 15Ω max.
*
Perform this operation when the engine
is cold.
RESISTOR INSPECTION
Remove the front cover. ( 2)
Disconnect the green/black and green wires
and measuring the resistance between the
wire terminals.
Resistance: 5Ω max.
If the needle remains at "∞", it indicates that
the resistor is faulty and must be replaced.
17-7
Unit: Ω
Upper
Lower
5~10
85~105
PEOPLE S 4T
Auto Bystarter Connector
Auto Bystarter Resistor