KYMCO PEOPLE S 125 Service Manual page 61

5
. FUEL SYSTEM
Connect a hose to the fuel enriching circuit of
the carburetor. Connect the auto bystarter
yellow wire to the positive (+) terminal of a
battery and green wire to the negative (-)
terminal. Wait 5 minutes and blow the hose
with mouth or vacuum pump. If the passage
is blocked, the auto bystarter is normal.
Disconnect the auto bystarter from the battery.
Wait 30 minutes and blow the hose with
mouth or vacuum pump. If air can be blown
into the hose, the auto bystarter is normal.
REMOVAL
Remove the set plate screws and set plate.
Remove the auto bystarter from the
carburetor.
AUTO BYSTARTER INSPECTION
Check the auto bystarter valve and needle for
nicks, wear or damage.
If any faulty part is found, replace the auto
bystarter as a set.
INSTALLATION
Insert the auto bystarter into the carburetor
body until it bottoms.
Position the set plate into the groove in the
auto bystarter and tighten the screws.
＊
• Be sure to install the auto bystarter and
set plate properly.
• Install the set plate with its bottom face
facing down.
5-5
Vacuum Pump
Screws
Bystarter Valve
Bystarter Needle
Auto Bystarter
PEOPLE S 4T
Adopter
Auto Bystarter
Set Plate
Screws
Set Plate