Printer Odometer; Label Type - CAS LP-II Service Manual

10 Printer Settings
If you press ENTER or SAVE, the scale will print a TPH (Thermal Print Head) test label at the indicated
speed and return to the previous screen.
Speed 1 is 4"/second (100 mm/sec); speed 5 is approximately 2"/second (50 mm/sec.)

10.4 Printer Odometer

At the Printer Hardware Settings
Menu screen, press the 3 key for
Printer Odometer. The Printer
Odometer screen will then
appear.
If you press FEED you will see the
odometer change.
This feature is useful to keep track of TPH (Thermal Print Head) life and printer wear & tear. If you replace
a TPH, you can write down the odometers value at the time of replacement so that if the new TPH were
to fail too soon, you would be able to tell how long that TPH was actually used for.
To exit, press the ESC key and the scale will return to the previous screen.

10.5 Label Type

At the Printer Hardware Settings
Menu screen, press the 4 key for
Label Type. The Label Type
screen will then appear.
For Label Type = 0, you will always
see this screen.
Label Type 0: This is the standard
fixed sized label media with liner backing paper. The Length value is the length of the label itself from
top to bottom. To capture the Length value, press the ALT key twice. The scale will feed out several
labels and automatically detect the length and the gap size. Please make sure that you have standard
"gapped" (non-continuous) labels in the printer whenever you execute this procedure.
Label Type 1: This is for continuous strip labels with liner backing paper. In this mode, the Gap Sensor is
not used as there are no gaps on continuous media.
For Label Type = 1 or 2, you will
always see this screen.
Label Type 2: This is linerless-
continuous strip label media or
receipt thermal paper. Both of
these do not have liner-backing
paper. Type 2 works the same as
Type 1 except that the pick-up
motor will not operate, as there
should be no liner to pick-up.
The printer has run for 20.532 Meters
Use FEED key to test
Press ALT for Auto Setup
< SET: LABEL TYPE >
Type (0-2):[0] 57mm X 99mm Labels
Width (25-80):
Length
Gap
< SET: LABEL TYPE >
Type (0-2):[1] 57mm Continuous Strip Label
Width (25-80):
Feed (0-170): [ 40] mm= 1.574 inches
Rcpt Feed (0-170): [ 10] mm= 0.393 inches
36
NUMERIC
[60] mm= 2.362 inches
40 mm= 1.574 inches
3 mm= 0.118 inches
[60] mm= 2.362 inches