CAS LP-II Service Manual page 25

5 Getting Started
3) Take the new roll of labels and find the ending. Peel-off and discard about one foot (12 inches) of
labels from the backing before installing the roll into the scale. Place the label in the scale as shown
and thread the backing through the appropriate places. (See fig.)
4) Please view the checkpoints on the diagram below as you read these directions to thread the labels.
Feed the backing paper over the width-adjusting Pressure Shaft lifting the Pressure Plate in order to
place the backing between the two making sure that the width adjustment is as exact as possible
without bending the backing paper.
Feed the backing paper inside the slot between the Gap sensor assembly making sure that the labels
travel under the Secondary width-adjuster.
Make sure that labels are pushed all the way to the left on the Peel-Off bar.
Feed the backing over the Rubber Roller and under the Print Head being careful not to touch the
underside of the Print Head.
Continue to feed the backing paper over the Peel-off Bar.
Continue to feed it under the Return Roller.
Feed the backing under and around the Pick-Up Shaft.
Now attach the Pick Up Spool assembly onto the Pick-Up Shaft and turn it slowly counterclockwise in
order to tighten the backing paper.
5) Push the Print Head down in order to lock it back in place. You will feel and hear it lock in place.
Close the printer access panel and press the ON/OFF key. You have completed the label roll installation.
(See fig.)
MAKE SURE YOU HAVE DONE
THE ADJUSTMENTS AT POINTS
1, 2, AND 3 BEFORE YOU LOCK
THE PRINT HEAD.
17