Gap Sensor Fine Adjust; Peel Sensor Fine Adjust; Print Speed - CAS LP-II Service Manual

10 Printer Settings
Once the threshold values
are printed they will also appear
on the top left corner of the
screen temporarily. Finally, the
screen will return to the Printer
Sensors menu.

10.2.2 Gap Sensor Fine Adjust

At the Printer Sensors Menu
screen, press the 2 key for Fine
Gap Adjust. You will see the
following screen:
Pressing the 1 key will
decrease the value by 1; the 2 will
decrease it by 5. Pressing the 3
key will increase the value by 1;
the 4 will increase it by 5.
Press the FEED key to the test alignment or press the SAVE key to save the changes.

10.2.3 Peel Sensor Fine Adjust

At the Printer Sensors Menu
screen, press the 3 key for Fine
Peel Adjust. You will see the
following screen:
Pressing the 1 key will
decrease the value by 1; the 2
will decrease it by 5. Pressing the
3 key will increase the value by 1;
the 4 will increase it by 5.
You can press the FEED key to test the status of the sensor: if there is a label waiting to be taken
then it will read BLOCKED; if you remove the label it will read UNBLOCKED. When finished, you can press
the SAVE key to save the
changes.

10.3 Print Speed

At the Printer Hardware Settings
Menu screen, press the 2 key for
Print Speed. The Print Speed
screen will then appear.
< CAL: PRINTER SENSOR CALIBRATION >
The Printer will calibrate sensors
and print threshold values.
GAP=
ADJUST GAP SENSOR THRESHOLD
1. Decrease
2. Decrease 5
USE FEED KEY TO TEST
ADJUST PEEL SENSOR THRESHOLD
1. Decrease
2. Decrease 5
< CAL: PRINTER SPEED >
Print Speed (1-5) :[1]
1= Fastest, 5= Slowest
35
102 PEEL=
3. Increase
4. Increase 5
THRESHOLD= 200
3. Increase
4. Increase 5
THRESHOLD= 125
150
NUMERIC