Getting Started; Installation Of The Label Roll - CAS LP-II Service Manual

5 Getting Started

5 Getting Started
5.1

Installation of the Label Roll

To install the label roll at ANY time you must follow the directions in this section:
1) Press the ON/OFF key and make sure that the display is completely off. Open the printer's side-
access panel. As you can see, there is a detailed diagram affixed onto the inside of the side-access
panel. Use this diagram (or this manual) for future reference on how to properly install the label roll.
(See fig.)
2) Find and remove the Pick-Up Spool assembly and the label-roll Pin. Also, find the Print Head Release
Lever and push it in the direction indicated. The print head will be in the "UP" position. If there were any
labels previously installed please remove all the collected backing paper from the Pick-Up Spool
assembly. The Pick-Up Spool assembly automatically collapses when it is removed from the Pick-Up
shaft. This makes the removal of the backing paper very simple. Also remove the cardboard paper roll
core if there was a label roll previously installed. (See fig.)
16