Yealink SIP-T48G Administrator's Manual page 61

Parameters
Description:
Enables or disables the IP phone to act as a DHCP server.
0-Disabled
1-Enabled
Note: It works only if the value of the parameter "network.pc_port.enable" is set to 1
(Auto Negotiation) and "network.bridge_mode" is set to 0 (As Router). If you change
this parameter, the IP phone will reboot to make the change take effect. It is only
applicable to SIP-T22(P) IP phones.
Web User Interface:
Network->PC Port->PC Port Config->Enable DHCP Server
Phone User Interface:
None
network.dhcp.start_ip
Description:
Configures the start IP address of the DHCP IP segment.
Note: It works only if the value of the parameter "network.pc_port.enable" is set to 1
(Auto Negotiation), "network.bridge_mode" is set to 0 (As Router) and
"network.pc_port.dhcp_server" is set to 1 (Enabled). If you change this parameter,
the IP phone will reboot to make the change take effect. It is only applicable to
SIP-T22(P) IP phones.
Web User Interface:
Network->PC Port->PC Port Config->Start IP Address
Phone User Interface:
None
network.dhcp.end_ip
Description:
Configures the end IP address of the DHCP IP segment.
Note: It works only if the value of the parameter "network.pc_port.enable" is set to 1
(Auto Negotiation), "network.bridge_mode" is set to 0 (As Router) and
"network.pc_port.dhcp_server" is set to 1 (Enabled). It works only if the value of the
parameter "network.bridge_mode" is set to 0 (As Router). It is only applicable to
SIP-T22(P) IP phones.
Web User Interface:
Network->PC Port->PC Port Config->End IP Address
Permitted Values
IP Address
IP Address
Getting Started
Default
10.0.0.10
10.0.0.100
49