Yealink SIP-T48G Administrator's Manual page 188

Microsoft Lync Edition Administrator's Guide for SIP-T2_Series and T4_Series IP Phones
1-Enabled
Note: If you change this parameter, the IP phone will reboot to make the change
take effect. It is only applicable to SIP-T48G IP phones. SLAAC is enabled on
SIP-T22(P) IP phones by default. You are not allowed to configure this parameter for
SIP-T22(P) IP phones.
Web User Interface:
Network->Advanced->ICMPv6 Status->Active
Phone User Interface:
None
To configure IPv6 address assignment method via web user interface:
1. Click on Network->Basic.
2. Select the desired address mode (IPv6 or IPv4 & IPv6) from the pull-down list of
Mode (IPv4/IPv6).
3. In the IPv6 Config block, mark the DHCP or the Static IP Address radio box.
If you mark the Static IP Address radio box, configure the IPv6 address and
-
other configuration parameters in the corresponding fields.
176
Parameters Permitted Values Default