Hardware Installation; Precautions; Requirements; Package Contents - Motorola AP-7131N-FGR Installation Manual

4
Motorola Solutions AP-7131N-FGR Access Point Installation Guide
2

Hardware Installation

An AP-7131N-FGR access point installation includes mounting the access point, connecting the
access point to the network, connecting antennae and applying power. Installation procedures vary
for different environments.
The AP-7131N-FGR model access point has the following port designations:
• GE1/POE - LAN port
• GE2 - WAN Port

2.1 Precautions

Before installing the AP-7131N-FGR, verify the following:
• Do not install in wet or dusty areas without additional protection. Contact a Motorola
Solutions representative for more information.
• Verify the environment has a continuous temperature range between -20° C to 50° C.

2.2 Requirements

The minimum installation requirements for a single-cell, peer-to-peer network:
• An AP-7131N-FGR model access point (in either of its two available dual-radio models)
• 48 Volt Power Supply (50-14000-247R) or Power Injector (AP-PSBIAS-1P3-AFR)
• A power outlet
• Dual-band antennae or an antenna specifically supporting the AP's 2.4 or 5 GHz band

2.3 Package Contents

Check package contents for the correct model AP-7131N-FGR and applicable accessories. Each
available configuration (at a minimum), contains:
• AP-7131N-FGR model access point (accessories dependent on SKU ordered)
• AP-7131N-FGR Install Guide (this guide)
• Wall mount screw and anchor kit
• Accessories Bag (4 rubber feet and a LED light pipe and badge with label for above the
ceiling installations)