Mounting The Access Point - Motorola AP-7131N-FGR Installation Manual

10 Motorola Solutions AP-7131N-FGR Access Point Installation Guide
1. Connect the Power Injector to an AC outlet (110VAC to 220VAC).
2. Connect an RJ-45 Ethernet cable between the network data supply (host) and the Power
Injector Data In connector.
3. Connect an RJ-45 Ethernet cable between the Power Injector Data & Power Out connector
and the access point's GE1/POE port.
NOTE
Ensure the cable length from the Ethernet source (host) to the Power Injector and access point
does not exceed 100 meters (333 ft).
The Power Injector has no On/Off power switch. The Injector receives power and is ready for
device connection and operation as soon as AC power is applied. Refer to the Installation Guide
shipped with the Power Injector for a description of the device's LEDs.

2.5 Mounting the Access Point

The AP-7131N-FGR can attach to a wall, mount under a suspended T-Bar or above a ceiling (plenum
or attic) following the same installation instructions. Choose one of the following mounting options
based on the physical environment of the coverage area. Do not mount the access point in a location
that has not been approved in a site survey.
2.5.1 Wall Mounting
Wall mounting requires hanging the access point along its width (or length) using the pair of slots on
the bottom of the unit and the access point mounting template (on the next page) for the screws.
CAUTION
Cabling the Power Injector to WAN port (GE2) renders the AP
non-operational. Only use a AP-PSBIAS-1P3-AFR (or AP-PSBIAS-1P2-AFR)
Power Injector with the access point's GE1/POE (LAN) port.
An access point should be wall mounted to concrete or plaster-
wall-board (dry wall) only. Do not wall mount the access point to
combustible surfaces.