Draytek Vigor2960 Series User Manual page 143

Vigor2960 Series User's Guide
interface re-connects, the traffic via other interface
will be interrupted immediately. The router will
use the specified interface for data transmission
again. Click Enable to enable such function. Or,
click Disable to disable such function.
When User Defined is selected as Out-going Rule

Outgoing Interface - Choose one of the profiles
to be used by such rule. In which, wan1 to wan2
profiles are configured in default.

Out-going (Gateway) – Type an IP address as the
gateway. Notice that LAN interface does not have
default gateway. You MUST specify a gateway if
you choose LAN as out-going interface.

Mode – Specify which mode (NAT or Routing)
will be used for such route rule.

Use IP Alias - Click Enable to enable such
function. Or, click Disable to disable such
function. When Enable is chosen, choose an alias
WAN IP address to replace the default WAN IP
address.

Failover to the Next Rule - When the specified
interface disconnects due to some reason, the
router can use next matched policy route rule to
perform data transmission automatically. Click
Enable to enable such function. Or, click Disable
to disable such function.

Failback (Quick Recover) - When the specified
interface re-connects, the traffic via other interface
will be interrupted immediately. The router will
use the specified interface for data transmission
again. Click Enable to enable such function. Or,
click Disable to disable such function.
When VPN Trunk LB Pool selected as Out-going Rule

Load Balance Pool – IPsec VPN trunk profile can
be selected by such policy route. You should
define the VPN trunk profile in VPN and Remote
Access >> VPN TRUNK Management >> Load
Balance Pool before

Mode – Specify which mode (NAT or Routing)
will be used for such route rule.

Failover to the Next Rule - When the specified
interface disconnects due to some reason, the
router can use next route rule to perform data
transmission automatically. Click Enable to
enable such function. Or, click Disable to disable
such function.

Failback (Quick Recover) - When the specified
interface re-connects, the traffic via other interface
will be interrupted immediately. The router will
use the specified interface for data transmission
135