Getting Started; Self-Checking; Quick-Start Operation - LifeSpan PERFORMER PLUS User Manual

While running, press it, speed turns to be 3km/h
（13）"speed 6" button
While running, press it, speed turns to be 6km/h
（14）"speed 9" button
While running, press it, speed turns to be 9km/h
（15）"speed up" button
Press it, speed increases by 0.1km/h per time
（16）"speed down" button
Press it, speed deceases by 0.1km/h per time

4.2 Getting Started

Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the power
switch located at the front of the treadmill below the motor shield. Ensure that the safety key is
installed, as the treadmill will not power on without it. When the power is turned on, all the
lights on the display will light for a short time.

4.3 Self-Checking

When using for the first time, it is necessary to make the machine carry on
self-check:
 Remove the safety key, press MODE and hold, then insert the
safety key again, the machine enters into self-checking state. During this state, pressing
START/STOP can terminate the self-checking.

4.4 Quick-Start Operation

1. Press and release the START/STOP to wake display up (if not already
on). Note: Installing the safety key will also wake up the console.
2. Press and release the START/STOP to begin belt movement, at 1.0 Km/hr, then adjust to
the desired speed using the '+' or '-'. You may also use the rapid speed keys (3, 6 and 9) to
adjust the speed. The speed range is from 1.0km/h to 22.0km/h. You can also use '+' or '-
'to adjust the speed on handrail.
3. To slow the treadmill down, press and hold the '
the rapid speed adjust keys: 3, 6, 9.
4. In a state of running, single press START/STOP, the walking belt will gradually slow down if
LIFESPAN PERFORMER PLUS 8
' key to desired speed. You may also press
-