Safety Key; Getting Started; Display Panel Operations - LifeSpan Equilizer XL User Manual

3 DISPLAY PANEL OPERATIONS

3.1 Safety Key

IMPORTANT: The treadmill will not operate if the safety key is not in place.
Before starting the treadmill, attach the magnetic key to the display panel, and then attach
the clip on the other end to your clothing (above the waist). If the safety key is removed
whilst you are operation the treadmill, the machine will turn itself off.
When the treadmill is not in use, you should remove the safety key.
Store the safety key in a safe place OUT OF REACH OF CHILDREN.

3.2 Getting Started

Power the treadmill on by plugging it into an appropriate wall outlet, then turn on the
power switch located at the front of the treadmill below the motor shield. Ensure that the
safety key is installed, as the treadmill will not power on without it.
When the power is turned on, all the lights on the display will light for a short time.
To start the treadmill, please press 'SPEED +'. You will hear a sound of the buzzer. To
increase and decrease the speed, you may use either speed up and down buttons or the
quick set buttons 2, 5, 8, 11 and 14. The maximum speed of the treadmill is 20km/h. To
increase and decrease the incline, you may use either incline up and down buttons or the
quick set buttons 3, 6, 9, 12 and 15.
In case of emergency, you may pull out the safety key off and the treadmill will stop
immediately.
LIFESPAN EQUALIZER XL Page 11